สืบค้นงานวิจัย
PERFORMANCE EVALUATION OF RUBBER, Hevea brasiliensis, TOWARDS COMMERCIALIZATION IN QUEZON PROVINCE
Cecilia N. Gascon - ไม่ระบุหน่วยงาน
ชื่อเรื่อง (EN): PERFORMANCE EVALUATION OF RUBBER, Hevea brasiliensis, TOWARDS COMMERCIALIZATION IN QUEZON PROVINCE
ผู้แต่ง / หัวหน้าโครงการ (EN): Cecilia N. Gascon
บทคัดย่อ (EN): In the Philippines, rubber production is mostly confined in Mindanao which has the best and uniform climate that brings sufficient rainfall throughout the year suitable for successful rubber production. However, this RDE project in the commercialization of rubber in Quezon Province funded by DA-BAR purportedly paved the way for the introduction of rubber production in the province. In general, Quezon Province is classified under type II climate characterized with no dry season and very pronounced maximum rain period which is different compared with Mindanao. The project was stationed in the town of Lucban, Quezon, approximately 600 km from the capital city, Manila. The town was nestled at the foot of majestic Mt. Banahaw which endowed it with cool weather and intermittent warm conditions throughout the year. Another project was set up in Tagkawayan, Quezon,.The project was aimed to document and assess the propagation and growth of rubber seeds and seedlings, growth and yield performance, pest and diseases problems of rubber trees and the problems (technical, economical, political, etc.) encountered during the conduct of the project. Results showed that rubber grows well in Quezon Province based from the germination and growth performance of most of the rubber plants in demo-farm and in two municipalities in Quezon Province. In terms of percent germination of seeds at different soaking time in plain water significantly affected percent germination of different seed sizes. In Lucban, Quezon the length of shoot produced by two rubber clones tested such as USM 1 and PB 260 was not influenced by dipping the shoot in different concentrations of ANAA. In terms of growth, measurement done after one year revealed that the original girth of 0.5cm and height of 35.54 cm, increased to 2.55 and 1.92 cm, respectively in one year period. Meanwhile , the leaves were seen with fairly unblemished foliage throughout the year though some moderate infections were observed on seedlings in the nursery. In Tagkawayan, Quezon, mean height and mean girth of four rubber clones tested, namely: PB 330, PB 311, PB 260 and RRIM 600 were not significantly different. However, In Lucban, Quezon, five clones, namely PB 330, PB 331, PB 260, RRIM 600 and USM 1 were found to have the same height after two years of growth while their girth was significantly different. The clone PB 330 had the biggest girth as compared with the other four clones tested. As regards pest and diseases of rubber in Quezon Province, only leaf blight was recorded affecting PB 330 and aphids affecting PB 260 clone. Training on natural rubber production technology, expansion of rubber budwood garden, planting of intercrops, and disposal of seedlings and plantable budgrafted seedlings were also conducted. The university continues to propagate seedlings in nursery and the commercialization of rubber production to meet the expected demand surge for planting materials from potential and interested growers in Quezon Province.
บทคัดย่อ: ไม่พบข้อมูลจากหน่วยงานต้นทาง
ภาษา (EN): en
เผยแพร่โดย (EN): การยางแห่งประเทศไทย
คำสำคัญ (EN): Quezon
เจ้าของลิขสิทธิ์ (EN): การยางแห่งประเทศไทย
หากไม่พบเอกสารฉบับเต็ม (Full Text) โปรดติดต่อหน่วยงานเจ้าของข้อมูล

การอ้างอิง

Cecilia N. Gascon. "PERFORMANCE EVALUATION OF RUBBER, Hevea brasiliensis, TOWARDS COMMERCIALIZATION IN QUEZON PROVINCE". ไม่ระบุหน่วยงาน. ม.ป.ป.

Cecilia N. Gascon. "PERFORMANCE EVALUATION OF RUBBER, Hevea brasiliensis, TOWARDS COMMERCIALIZATION IN QUEZON PROVINCE". ไม่ระบุหน่วยงาน. ม.ป.ป.. Print.



TARR Wordcloud:
PERFORMANCE EVALUATION OF RUBBER, Hevea brasiliensis, TOWARDS COMMERCIALIZATION IN QUEZON PROVINCE
Cecilia N. Gascon
การยางแห่งประเทศไทย
ไม่ระบุวันที่เผยแพร่
Development and Promotion of Rubber (Hevea brasiliensis Muell Arg.) Towards Commercialization in Oriental and Occidental Mindoro EFFECT OF PLANTING DENSITY ON GROWTH AND YIELD OF RUBBER (HEVEA BRASILINENSIS) IN NORTH EASTERN INDIA cDNA-AFLP ANALYSIS REVEAIS DIFFERENTIAL GENE EXPRESSION IN BPM 24 CLONE OF HEVEA BRASILIENSIS EXHIBITING TAPPING PANEL DRYNESS (TPD) FEASIBILITY OF RUBBER (Hevea brasiliensis Mull. Arg.) CULTIVATION IN THE EASTERN PROVINCE OF SRI LANKA; A NON TRADITIONAL AREA FOR RUBBER Long-Term Yield and Growth Performance of IRCA Rubber Clones (Hevea Brasiliensis) in India Evaluation of Rubber (Hevea brasiliensis) Modern Clones under Certain Stressful Climatic Conditions of Odisha Performance of Selected Exotic and Indigenous Rubber (Hevea brasiliensis) Clones in Traditional Region of Kerala, India BIOMOLECULES CONTENTS AND RUBBER PROPERTIES OF SOME HEVEA BRASILIENSIS CLONES Effect of Temperature Constraints on Photosynthesis of Rubber (Hevea brasiliensis) Cultural and Morphological Characterizations of Fusicoccum sp., the causal agent of rubber (Hevea brasiliensis) leaf blight in Malaysia
คัดลอก URL
กระทู้ของฉัน
ผลการสืบค้นทั้งหมด โพสต์     เรียงลำดับจาก
พัฒนาระบบโดยศูนย์ความรู้เฉพาะด้านวิศวกรรมความรู้และวิศวกรรมภาษาDeveloped by Center of Excellence for Unified Knowledge and Language Engineering
สนับสนุนโดยสำนักงานพัฒนาการวิจัยการเกษตร (องค์การมหาชน)Supported by the Agricultural Research Development Agency (Public Organization)
แบบสำรวจความพึงพอใจQuestionair